Serving the St. Louis area  ·  (314) 689-1531  ·  Open Mon-Sun 7am-7pm
📞 (314) 689-1531 Free Quote

Metal Roofing in University City, MO (63130) · Local Professionals

St. Louis Metal Roofing · Fast response in University City and the St. Louis area · Free estimate 24h

✅ Metal Roofing Alliance Member 🛡️ Licensed & Insured 💸 Free Quote 24h 🕐 Mon-Sun 7am-7pm
+12Verified Reviews
17Years in Business
4.9 ★Google Rating
24/7Available
✅ No hidden fees💳 Cards accepted🛡️ Licensed & Insured✅ Metal Roofing Alliance Member

University City is a tight grid of early 1900s brick homes, from the Four-Family Flats near the Loop to the stately Tudors off Hanley Road, and those roofs take a beating. The original slate and clay tile have mostly been replaced, but the steep pitches, parapets, and chimneys that define these houses are still the first places to leak when ice dams up or a sycamore limb comes down.

We are St. Louis Metal Roofing, and since 2009 we have been climbing the ladders on these same streets, from the 63130 ZIP code out through Clayton and Richmond Heights. When a homeowner near Heman Park calls about a stain on the ceiling, we know it is usually a failed flashing at the chimney or a seam that opened up after a hail storm, not a mystery.

Metal Roofing in University City (63130)

Most of the housing stock here was built between 1900 and 1950, which means we are often working on steep roofs with multiple valleys, dormers, and brick chimneys that need careful flashing. The lots are narrow, and mature pin oaks and sycamores hang over many drives, so we plan for tight staging and use magnetic sweepers to catch every screw and rivet. The ground is mostly flat to gently rolling, but older homes often have settled gutters and short downspouts that dump water right at the foundation, so we check drainage before we ever quote a metal roof. Parapet walls on the flat-roofed commercial buildings along Olive and Delmar also need special attention because that is where wind-driven rain finds the smallest gap.

Our team has been serving University City and the surrounding St. Louis area since 2009, and we are a Metal Roofing Alliance member, fully insured with general liability and workers' compensation.

Our services in University City

How a Job Works in University City

Step 1: You call (314) 689-1531 or send a message, and we schedule a free on-site assessment. We walk the roof, check the attic if accessible, and look at the flashing, fasteners, and seams. You get a written estimate with options, not pressure.

Step 2: Once you approve, we pull the required permits through the city and coordinate any historic district or HOA design review if your home is in a designated area. On tight streets near the Loop, we stage materials in the driveway or use a boom truck only where the city allows it, and we protect landscaping with tarps and plywood.

Step 3: Cleanup is part of the job. We run magnets over the yard and drive, haul away all old roofing and debris, and do a final walkthrough with you to make sure you are satisfied before we pack up.

Pricing in University City depends on the size and pitch of your roof, how many layers are already there, and how much flashing and trim work is needed. As a ballpark, metal roof installation starts around $8 per square foot, standing seam runs from $10 per square foot, and a full replacement starts around $9 per square foot. If you are going over existing shingles, retrofit pricing starts at $7 per square foot, but code limits how many layers you can cover. Repairs start at $450, and leak repairs also start at $450. Screw replacement and re-fastening starts at $750, and flashing or chimney repair starts at $600. We give free estimates, so call (314) 689-1531 and we will give you a real number for your house, not a phone guess.

✅ Metal Roofing Alliance Member, licensed and insured for work in University City and nearby areas.

My brick Tudor near the University City Loop has a leak at the chimney. Is that common?
Very common. The original flashing around brick chimneys often fails after decades of freeze-thaw, and the mortar joints can crack. We repair or replace the flashing with proper counterflashing and sealant, and we check the chimney crown too. If the leak has been going on a while, we also look for rot in the sheathing.
A storm just took down a big oak limb on my roof in University City. Can you come out fast?
Yes. We handle storm and wind damage repair and offer free inspections. Call (314) 689-1531 and we will schedule a prompt visit. We can tarp or make temporary repairs if needed, and we document the damage for your insurance claim. We never promise coverage, but we give you the photos and notes your adjuster will want.
What does a typical metal roof cost for a 1,500 square foot brick bungalow in 63130?
For a house that size, a basic corrugated or ribbed panel roof might start around $8,000 to $12,000, while standing seam could run $15,000 to $22,000, depending on pitch, tear-off, and trim. Repairs are often $450 to $1,500. The only way to know is a free on-site estimate, so call (314) 689-1531.
Do I need a permit for a metal roof replacement in University City?
Yes, roofing permits are commonly required for a full replacement or re-roof, and the rules vary by jurisdiction. We handle the paperwork and inspections for you. For specifics on your property, check with the City of University City website or call the building department, and we will coordinate with them as part of the job.
My neighbor's tree hangs over my roof and my HOA has rules about metal roof color. Can you help?
We can. We are familiar with HOA and historic district design review in University City and can provide color samples and panel profiles for approval. As for the tree, that is a property line issue between you and your neighbor, but we can trim back limbs that are over your roof during the job if you have permission.
Are you insured for work on my University City home?
Yes, we are fully insured with general liability and workers' compensation. We are happy to provide a certificate of insurance before we start, so you have peace of mind.
What should I do to prevent ice dams on my metal roof in University City?
Ice dams form when heat escapes the attic and melts snow that refreezes at the eaves. Make sure your attic is well insulated and ventilated, and consider snow guards or ice protection on north-facing slopes. We install snow guards starting at $1,200. A free inspection in the fall can catch problems before winter.
Why choose us?

Trusted professionals since 2009

🏅

Licensed contractors

Continuous training, professional equipment, meticulous and code-compliant work

🛡️

Licensed & Insured

Full coverage on all our job sites, no exceptions

⚡

Available Mon-Sun 7am-7pm

Emergencies, weekends, holidays: available when you need us

💰

100% Free Quote

Response within 24h, no commitment, by phone or form

Our services

Our Metal Roofing Services in St. Louis

All your work handled by qualified professionals in St. Louis

Metal Roof Installation

Complete metal roof systems engineered for your local climate and built to outlast three shingle roofs.

Included in your service

  • Deck inspection and repair before any panel goes on
  • High-temp synthetic underlayment and correct ridge and soffit ventilation
  • Manufacturer-certified panel, trim, and flashing details for the full warranty
  • Free on-site assessment and written estimate within 24h
Learn more→

Standing Seam Metal Roofing

Concealed-fastener standing seam: no exposed screws to loosen, leak, or need re-torquing.

Included in your service

  • Panels roll-formed to the exact length of your roof, no end laps
  • Mechanically seamed or snap-lock profiles with concealed clips
  • Floating clip system that lets panels expand and contract freely
  • Kynar 500 / PVDF finish in the full architectural color range
Learn more→

Metal Roof Replacement

Full tear-off of an end-of-life shingle, cedar, or metal roof, replaced with a complete new system.

Included in your service

  • Tear-off and haul-away of the old roofing, dumpster included
  • Decking inspected board by board, rot and soft spots replaced
  • New underlayment, drip edge, valleys, and penetration flashing throughout
  • Documentation of the finished system for your insurer or future buyer
Learn more→

Metal Roof Over Shingles (Retrofit)

Retrofit metal installed over sound existing shingles: no tear-off, less waste, lower cost.

Included in your service

  • Honest deck and shingle assessment first, recover only when it is the right call
  • Furring strips or slip sheet as the panel profile and local code require
  • Existing vents, pipe boots, and flashings reworked to the new roof plane
  • Straight guidance on when tear-off is the better long-term choice
Learn more→

Metal Roof Repair

Targeted repair of damaged, loose, or storm-hit metal roofing before it reaches your ceiling.

Included in your service

  • Bent, dented, or punctured panels replaced and color-matched
  • Seams, laps, and penetrations resealed with compatible butyl and sealant
  • Failed pipe boots, closures, and ridge cap fasteners renewed
  • Written findings with photos of what we found and what we fixed
Learn more→

Metal Roof Leak Repair

Priority leak response: we trace the leak to its real source instead of caulking the symptom.

Included in your service

  • Water testing and interior tracing to find the true entry point
  • Backed-out fasteners, separated seams, and flashing gaps corrected at the cause
  • Emergency tarping available same day after a storm
  • Attic and insulation moisture check so hidden damage does not sit and spread
Learn more→

Screw Replacement & Re-Fastening

The top cause of leaks on 15 to 30 year old screw-down roofs, fixed for a fraction of replacement.

Included in your service

  • Every fastener replaced with oversized screws and new EPDM sealing washers
  • Dried-out washers and stripped holes addressed panel by panel
  • Ridge, eave, and sidewall closures renewed at the same time
  • Restores a watertight roof without replacing sound panels
Learn more→

Corrugated & Ribbed Panel Roofing

Corrugated, tuff-rib, and 5V panel roofing: the budget-friendly workhorse for homes and outbuildings.

Included in your service

  • Galvalume and painted steel panels cut to length on site
  • Correct screw pattern and torque so washers seat without over-driving
  • Foam and metal closures at ridge, eave, and rake to keep weather and pests out
  • Full color range for homes, cabins, barns, and workshops
Learn more→

Metal Shingle Roofing

The look of architectural shingle, slate, or shake with the lifespan and wind rating of steel.

Included in your service

  • Interlocking stamped steel or aluminum shingle panels
  • Walkable finished surface, easier to service than a standing seam field
  • Lightweight enough for retrofit over an existing roof structure
  • Profiles and colors that suit historic and HOA-governed neighborhoods
Learn more→

Stone-Coated Steel Roofing

Steel strength under a textured stone finish, with strong hail and wind performance.

Included in your service

  • Acrylic-bonded stone granule surface over structural steel
  • Battened or direct-to-deck installation depending on the profile
  • Class A fire rating and high impact resistance ratings
  • Tile, shake, and shingle textures for suburban and coastal homes alike
Learn more→

Copper & Specialty Metal Roofing

Copper, zinc, and aluminum for porches, bay windows, dormers, and full architectural roofs.

Included in your service

  • In-house fabrication of pans, valleys, and custom curved details
  • Soldered seams and joints where the detail calls for it
  • Isolation of dissimilar metals to prevent galvanic corrosion
  • A living patina that develops over decades of service
Learn more→

Metal Roof Coating & Painting

Restoration for faded, chalking, or surface-rusted metal, adding 10 to 15 years without replacement.

Included in your service

  • Wash, degrease, and mechanical prep of the entire panel surface
  • Rust treatment and primer on affected areas before topcoat
  • High-performance elastomeric or silicone coating system applied to spec
  • Honest assessment first: we say so when the roof is past coating
Learn more→

Flashing, Chimney & Skylight Repair

Flashing is the number one leak point on any metal roof, and it is what we fabricate best.

Included in your service

  • Custom bent step, counter, and apron flashing made in-house
  • Chimney crickets to shed water on the uphill side
  • Skylight curbs and head flashing rebuilt to the panel profile
  • Valley and wall transition details closed with matching trim
Learn more→

Snow Guards & Ice Protection

Snow retention that stops rooftop avalanches onto decks, gutters, walkways, and entryways.

Included in your service

  • Pad-style guards or continuous rail systems matched to your panel
  • Layout calculated from roof pitch, panel length, and local snow load
  • Clamp-on mounting on standing seam, no panel penetrations
  • Ice dam and eave detailing for higher-elevation homes
Learn more→

Storm & Wind Damage Repair

Wind, hail, and fallen-limb repair with thorough documentation and a straight repair-or-replace answer.

Included in your service

  • Free post-storm inspection with dated photo documentation
  • Emergency tarping and temporary weatherproofing when needed
  • A written report you can use when documenting your insurance claim
  • Honest assessment of repair versus replacement, with no pressure either way
Learn more→

Metal Roof Inspection

A written, no-obligation assessment of fastener condition, seams, flashing, and remaining service life.

Included in your service

  • Fastener, washer, and seam condition checked across the field
  • Flashing, penetrations, and closures inspected point by point
  • Coating wear, chalking, and corrosion graded panel by panel
  • Written report with photos and a straight answer on years remaining
Learn more→

Gutters for Metal Roofs

Gutters sized and hung correctly for metal roofing, where standard hangers and spacing do not work.

Included in your service

  • Seamless aluminum or half-round systems formed on site
  • Hanger placement and spacing matched to the panel profile
  • Oversized capacity and downspouts sized for heavy regional rainfall
  • Bracket spacing tightened for high-wind zones so storms do not tear the gutter off
Learn more→

Commercial & Agricultural Metal Roofing

Barns, workshops, churches, and light commercial metal roofing across the county.

Included in your service

  • Long-run panels for wide spans and low-slope structures
  • Purlin and framing attachment detailed for the building type
  • Insulation, vapor barrier, and condensation control options
  • Repairs and re-fastening for aging agricultural metal buildings
Learn more→
Verified client reviews

12+ Verified Client Reviews in St. Louis

⭐⭐⭐⭐⭐ 4.9/5 · 12 verified Google reviews

Free Quote

Get Your Free Quote

Metal Roofing in St. Louis · Response within 24h · No commitment · ☎ (314) 689-1531

Your Free Quote Request

Confidential · Response within 24h

✅ Free personalized estimate ⚡ Response within 24h 🛡️ Licensed & Insured 📍 On-site visits included in St. Louis ✅ No hidden fees 🕐 Available Mon-Sun 7am-7pm